MORPHOLOGICAL OBSERVATION OF SINGLE-CHAIN POLY (METHYL METHACRYLATE) PARTICLES*

Tapping mode atomic force microscope has been applied to observe single-chain PMMAparticles which were stored for six months at room temperature after sprayed from verydilute solutions in good solvents, good/poor mixed solvents, and a theta solvent. Monodis-perse PMMA standards of molecular weights ranging from 7.90×10~4 to 1.3×10~6 wereused to investigate the effect of molecular weight oh the size of the single-chain PMMAparticles. These single-chain particles showed close to spherical shapes. The morphologyof single-chain PMMA particles of a given molecular weight was found to be identical inspite of different solvents used for solution spraying. Molecular weigh dependence of theparticle dimension was also found. The diameters of single-chain PMMA particles aftercorrection of tlp-geometry effect were compared to the values estimated from molecularweight and density.     

Selective desorption and analysis of humic substances on suspended particles in river water

The elemental analysis and morphology of individual particles indicate that the dominant suspended particles in river water are kaolin covered with hydrated iron(III) oxide which strongly sorbs humic substances. Suspended particles, about 1 mg, collected from 250 ml of water by centrifugation, are treated with 0.7 ml of 0.1M sodium hydroxide to desorb humic substances. Approximately 60% of copper and 30% of lead on or in suspended particles exist as humic complexes.     

Preconcentration of Trace Elements in Water for Speciation Studies

Trace element speciation has recently become one of the most important problems in water analysis. Proper combination of preconcentration techniques with instrumental determination methods is essential to speciation analysis, because sensitivity and selectivity of direct determination methods are generally lacking. The present paper describes such preconcentration techniques as filtration, centrifugation, flotation and sorption, which have been developed in the author's laboratory for the speciation of heavy metals in river and pond waters by electron microscopy, X-ray microanalysis and chemical analysis. The application of freeze concentration to the speciation of silica in high-purity waters is also discussed.     

Sub-Doppler rotationally resolved spectroscopy of lower vibronic bands of benzene with Zeeman effects

Sub-Doppler high-resolution excitation spectra and the Zeeman effects of the 6(0)(1), 1(0)(1)6(0)(1), and 1(0)(2)6(0)(1) bands of the S1(1)B2u<--S(0)(1)A1g transition of benzene were measured by crossing laser beam perpendicular to a collimated molecular beam. 1593 rotational lines of the 1(0) (1)6(0) (1) band and 928 lines of the 1(0)(2)6(0)(1) band were assigned, and the molecular constants of the excited states were determined. Energy shifts were observed for the S1(1)B2u(v1=1,v6=1,J,Kl=-11) levels, and those were identified as originating from a perpendicular Coriolis interaction. Many energy shifts were observed for the S1(1)B2u(v1=2,v6=1,J,Kl) levels. The Zeeman splitting of a given J level was observed to increase with K and reach the maximum at K=J, which demonstrates that the magnetic moment lies perpendicular to the molecular plane. The Zeeman splittings of the K=J levels were observed to increase linearly with J. From the analysis, the magnetic moment is shown to be originating mostly from mixing of the S1(1)B2u and S2(1)B1u states by the J-L coupling (electronic Coriolis interaction). The number of perturbations was observed to increase as the excess energy increases, and all the perturbing levels were found to be a singlet state from the Zeeman spectra.     

Succession of stacking disorder in hard-sphere crystal under gravity by Monte Carlo simulation

We have performed Monte Carlo simulations of hard spheres under gravity. Vertical boundaries are hard walls, which are well separated with each other. On the other hand, the periodic boundary condition is imposed in the horizontal direction. While we previously reported enhancement of crystallinity as well as crystallization due to gravity, we present here the results that demonstrate the succession of a defect. In case that the crystal formed at the bottom of the system includes kinds of stacking disorders for the (0 0 1) growth, twin band structure develops as mediated by a stacking disorder succeeded in the crystal formed in the fluid region which lies on the bottom crystal. In case that the stacking structure along horizontal direction changes from the (1 1 1) stacking to the (0 0 1) stacking, twin band structure in the (0 0 1) stacking region develops as succeeded in the crystal transformed. The twin band structure also becomes large with its upward growth.     

Soluble polymer-supported catalysts containing pendant quaternary onium salts for the addition reaction of oxiranes with carbon dioxide

The addition reaction of oxiranes ( 15a-d ) with carbon dioxide (CO₂) was carried out using 1 mol % of soluble polymer-supported quaternary onium salts as catalysts under atmospheric pressure. The reaction of 15a-d with CO₂ proceeded very smoothly to give the corresponding five-membered cyclic carbonates ( 16a-d ) in high yields at 90-100°C. The catalytic activity of the soluble polymer-supported quaternary onium salts was strongly affected by the following factors: kind of reaction solvent, degree of introduction of the pendant onium salt residues in the polymer chain, and type of alkyl group on the onium salts due to the balance between lipophilicity and steric hindrance of the onium salt residue. Furthermore, these soluble polymer-supported quaternary onium salts were found ordinarily to have higher catalytic activity than low molecular weight quaternary onium salts under the same reaction conditions. It was also found that the rate of reaction was proportional both to catalyst concentration and to oxirane concentration. © 1995 John Wiley & Sons, Inc.     

Adsorption and reactions of NO on clean and CO-precovered Ir(111)

Adsorption and reactions of NO on clean and CO-precovered Ir(111) were investigated by means of X-ray photoelectron spectroscopy (XPS), high-resolution electron energy loss spectroscopy (HR-EELS), infrared reflection absorption spectroscopy (IRAS), and temperature-programmed desorption (TPD). Two NO adsorption states, indicative of fcc-hollow sites and atop sites, were present on the Ir(111) surface at saturation coverage. NO adsorbed on hollow sites dissociated to Na and Oa at temperatures above 283 K. The dissociated Na desorbed to form N2 by recombination of Na at 574 K and by a disproportionation reaction between atop-NO and Na at 471 K. Preadsorbed CO inhibited the adsorption of NO on atop sites, whereas adsorption on hollow sites was not affected by the coexistence of CO. The adsorbed CO reacted with dissociated Oa and desorbed as CO2 at 574 K.     

Direct chiral resolution of tartaric acid by ion-pair capillary electrophoresis using an aqueous background electrolyte with (1R,2R)-(-)-1,2-diaminocyclohexane as a chiral counterion

Chiral resolution of native DL-tartaric acid was achieved by ion-pair capillary electrophoresis (CE) using an aqueous-ethanol background electrolyte with (1R,2R)-(-)-1,2-diaminocyclohexane (R-DACH) as a chiral counterion. Factors affecting chiral resolution and migration time of tartaric acid were studied. By increasing the viscosity of the background electrolyte and the ion-pair formation, using organic solvents with a lower relative dielectric constant, resulted in a longer migration time. The optimum conditions for both high resolution and short migration time of tartaric acid were found to be a mixture of 65% v/v ethanol and 35% v/v aqueous solution containing 30 mM R-DACH and 75 mM phosphoric acid (pH 5.1) with an applied voltage of -30 kV at 25 degrees C, using direct detection at 200 nm. By using this system, the resolution (Rs) of racemic tartaric acid was approximately 1. The electrophoretic patterns of tartaric and malic acids suggest that two carboxyl groups and two hydroxyl groups of tartaric acid are associated with the enantioseparation of tartaric acid by the proposed CE method.     

Fabrication of polymer Langmuir-Blodgett films containing regioregular poly(3-hexylthiophene) for application to field-effect transistor

Semiconducting thin films consisting of regioregular poly(3-hexylthiophene) (RR-PHT) and poly(N-dodecylacrylamide) (pDDA) were constructed by the Langmuir-Blodgett (LB) technique. A mixture of RR-PHT and pDDA spread from a chloroform solution on a water surface forms a stable monolayer, which can be transferred onto solid substrates by the LB method, yielding a well-defined polymer LB film. Surface morphology studies of the LB film indicate that the RR-PHT is dispersed uniformly throughout the surface. The polymer thin film was chemically doped by contacting with FeCl3 acetonitrile solution, and a conductivity of 5.6 S/cm was achieved. Further, the LB film was utilized as the semiconducting film in the field-effect transistor (FET), and mobilities of 2.2 x 10(-4) and 4.4 x 10(-4) cm2 V(-1) s(-1) were obtained by analyzing the saturated and linear regions of the current-voltage characteristic, respectively.     

The effect of gas injection on a thermal argon plasma flow in a water-cooled tube

The effect of gas injection on an atmospheric thermal argon plasma flow in a water-cooled tube was investigated experimentally and numerically. The injection gas is argon, helium, or nitrogen. The static pressure with helium injection increases greatly because of its high thermal conductivity, while little increase occurs for nitrogen injection because of the dissociation. The increasing rate of the static pressure depends on the ratio of the momentum term to the viscosity term. The heat flux to the tube wall with gas injection changes less than that without injection. The numerical results showed variations similar to the experimental ones.